Welcome to Dongguan Ruikun Material Technology Co.,Ltd.

Trinidad and Tobago What are the No Foam for paints(1)

2023-04-14

Trinidad and Tobago Selection of antifoaming agents for different applications:

Flat coating

Features: Low viscosity, low defoaming pressure

Recommendation: Mineral oils or mineral oil modified polyethers

Elastic coating

recoating

Features: High viscosity, high No Foam pressure

Recommendation: Polyether modified silicone

Defoamer is an additive for eliminating foam. A large amount of foam will be produced in the production and application process of coatings, textiles, medicine, fermentation, paper making, water treatment, petrochemical and other fields, which will affect the product quality and production process. Based on the inhibition and elimination of foam, a specific amount of defoamer is usually added to it during production

Surface coating and film covering adhesive

not

Recommendation: Polyethers, which can effectively prevent surface defects and have a small impact on gloss

Attenuation mechanism of foam
Under the condition of gravity and pressure difference, the liquid membrane of foam will flow and discharge liquid unevenly, and the gas in the bubble will continue to diffuse and permeate due to the different pressure difference on both sides of the bubble membrane, so the instability of foam itself is mainly reflected from the dynamics. [4]
The attenuation mechanism mainly includes the diffusion of gas through the liquid film and the discharge of liquid from the liquid film. These two properties are inherent attributes of foam itself, and have nothing to do with the existence of surfactant. However, these two attenuation mechanisms only play an obvious role in the initial stage of foam system formation. With the attenuation of foam system, these two effects gradually weaken, making the foam attenuation rate gradually slow. [

Water in Water Colorful

Powder is defined as a substance that can reduce the aggregation of solid or liquid particles in a dispersion system. When adding dispersants and suspensions to the preparation of emulsifiable concentrates and wettable powders, it is easy to form dispersants and suspensions and maintain the relatively stable function of the dispersion system

Features: More surfactants, stable foam

water-based

wetting

water-based

Trinidad and Tobago Recommendation: Use polyethers or mineral oil to modify polyethers

Precautions for use of paint No Foam:

Before use, stir thoroughly and mix evenly; Adding the paint while stirring; Before use, it is generally not diluted with water; The dosage should be appropriate. Excessive dosage can cause shrinkage, edge shrinkage, poor brushing performance, and other problems; Too little dosage leads to poor defoaming effect; Add it in two stages, namely, add it in the grinding stage and the paint mixing stage, generally accounting for half of the total amount each time. Use defoaming agents with good foam suppression effect in the grinding stage, and use defoaming agents with good foam breaking effect in the paint mixing stage